Why oil goes first
Oil is the low-risk step. It costs a few minutes and a squirt, with no torch involved. Start with it, give it time, and try gentle torque. A surprising number of parts move without anything else.
When heat becomes an option
Heat expands the nut and can help break the grip of rust. It is only an option when the surroundings can take it and the joint is not near fuel, brake lines, wiring, plastic, rubber or other parts that burn. Aluminum around steel is a special case: it expands and softens at lower temperatures than steel, so know the material before you reach for a torch.
- Wipe the penetrant off the area first so it does not flare.
- Have the right extinguisher and ventilation, and never heat a closed vessel.
- Heat the nut or outer part, not the stud inside it.
Where heat is off the table
Brake components, fuel and gas fittings, anything near hoses and wiring, and fasteners in sensitive parts call for patience and penetrant, not flame. Each of our job pages has a heat call, from "heat OK" to "no heat," with the reason.