Rough soak times
- Light surface rust, recently stuck: about 15 minutes.
- Moderate corrosion, a bolt that has not moved in a year or more: one to two hours.
- Heavy corrosion, road-salt exposure, or decades of neglect: overnight, with fresh applications.
Reapply, do not just wait
The thin fluid works its way in slowly and can drain or evaporate off a vertical surface. If the part is stubborn, spray again every so often rather than relying on one coat. Position the work so gravity feeds the fluid into the thread where you can.
Help the oil along
Wire-brush away loose rust first so the fluid reaches the thread and not the crud. A few light taps with a hammer on the nut or bolt head (not hard enough to deform it) can help the fluid move into the joint. Then test with gentle torque in both directions rather than forcing it one way.
If it still will not move
Stop short of rounding the fastener. Check the specific job page for that part: some parts take heat, and some, like brake and fuel components, do not. Our seized-bolt guide lays out the full method.